Ubiquiti ETH-SP-G2 Surge Suppressor/Protector True-Tech

Ubiquiti ETH-SP-G2 Surge Suppressor/ProtectorDimensions 91 x 61 x 32.5 mm
(3.58 x 2.4 x 1.28″)
Weight 80 g
(2.82 oz)
Interface Connections (2) RJ45 Female Connectors
ESD/EMP Protection Absorbing Transient Current with Response to
Surge Voltage from 100V/s to 1kV/µs
DC Spark-Over Voltage 90V @ 100V/s
Maximum Impulse Spark-Over Voltage 700V @ 1kV/µs
Discharge Current 10kA+
Maximum Insulation Resistance 1G ohm @ 50V
Maximum Capacitance 1.0 pF @ 1 MHz
Data Line Protection RJ45 10/100/1000 Ethernet
IEEE 802.3af PoE Support Yes
Shock and Vibration Certification ETSI300-019-1.4 Standard
Operating Temperature -30 to 65° C
(-22 to 149° F)
Operating Humidity 10 to 90% NonIntroducing the next generation Ethernet
Surge Protector, model ETH-SP-G2, from
Ubiquiti Networks. The ETH-SP-G2 is a
cost-effective solution for protecting
outdoor Ethernet devices from damaging
electrostatic discharge and surges. Since
all Ubiquiti® airMAX® devices already
have robust ESD protection built in,
adding the ETH-SP-G2 to the installation
provides an additional layer of protection
to the network.
The ETH-SP-G2 is engineered to protect
Power-over-Ethernet (PoE) or non-PoE
devices with connection speeds of up to
1 Gbps. Two passive, surge-protected
RJ45 connections provide maximum
equipment compatibility.
Ideal for WISP Networks
All Ubiquiti airMAX devices are equipped
with ESD protection. However, to protect
outdoor devices, and to meet certain
local code requirements, installing the
ETH-SP-G2 is essential.
For example, to guard against costly
service calls, and to help your subscriber
installations meet code requirements,
install two ETH-SP-G2 devices: one near
the CPE, and the other at the entry point to
the building. Damaging ESD attacks
and surges will be absorbed by the
ETH-SP-G2 devices and